Following reasons cause the failure of laser working (has no laser beam) 1. Cooling system problem (includes water chiller) 2. Laser power supply (optical coupled isolator) or Laser tube 3. Wiring or Controller 1. If there shows “water.

1. Please check if the rotary switch is turned on,like below: PS: Turning to "O" off means all is normal. If it is "-", please turn off to “O” and press the reset on control panel. 2..

This problem may cause from improper setting of the software. Please start up the laser software RDWorksV8. And then click “Config” – “system setting” on the menu bar. This dialog box appears. Make sure “Axis X.

If the file being imported is DXF format, the problem may be caused by improper software setting. For example, the unit of the original DXF file is “inch”, but in RDWorks, the DXF unit is.

If there are several USB interfaces with your PC, it's able for one PC (laser software) to connect with several machines. But pc will does only communicate with one machine and sending the file into.

1. Firstly run CorelDraw and set the parameter following below instructions: 2. After that, close CorelDraw. Double click to open RDWorks installation program. Choose the type of CorelDraw_Laser (be sure the RDWorks main program has.

1. RDWorks cannot read PDF and open it directly. 2. Use CorelDraw to open/import PDF file. Then save the graphic as DXF file. Like below: 3. Then RDWorks can read the DXF file, Just import the.