In response to national call for independent innovation, to promote and cultivate more innovation projects and independent learning talent, Thunder Laser cooperate with Shenzhen SEG setting up an experience center to help more children.
There are three cases.
1. Two sides of the working table are not of the same height.
Turn off the whole machine power, manually pull one of the belts of Z axis so as to adjust.
Some point of the same piece of materials cannot be cut through, why?
This problem is mainly caused by following three reasons:
1. The cutting material is bent (not flat) or uneven density.
2. The working table.
The Cooperation Between Thunder Laser and Guangdong Mechanical and Electrical Polytechnic（GMEP）for employment promotion Of College Students .
Mr.Chen, CEO of Thunderlaser, has been always concerned about the development of his mother school after graduating from.
Drive belts is an important part of getting the X,Y,Z axis moving, Low quality belts would age fast after high speed moving, this will result a bad impact on the cutting engraving effect. Thunder.
