Here are the reasons:
● Exhaust fan break down
How to check if exhaust fan break down, there’s a common way to connect it to the power directly using the power cable of.
Scenario 1:
If the vector has overlapped paths and it will be cut repeatedly.
Solution：
In RDworks, you can use “Delete overlap” tool to delete all overlapped paths,.
Note: the laser machine can only burn into or through material. Also, the beam can only be made to follow straight or curved paths or to burn a grid of dots (a.
Here are the reasons:
● The needed focus is lost
The bending of the material or the uneven working table can result in different focal lengths, especially for the.
The engraving quality working on x-swing is generally worse than x-unilateralism, it usually results in ghosting effect or image offset or bi-directional engraving offset, like below.
In RDworks, you can.
Here are the reasons:
● The needed focus is lost
The bending of the material or the uneven working table can result in different focal lengths, especially for the large engraving.
Here are the reasons:
● The laser switch is off
Please make sure laser switch is on, then open lower left hand door panel (or back side door panel), check if the laser .
