LCD panel shows the following information:
Our machine has sensors for door protection (front cover and laser tube cover), like below.
Please close both of them before start to work.
Home » laser cutter machine » Alarm message of LCD panel—Machine protected
Related Posts
01
Jun,2019
Here are the reasons:
● The red dot pointer is off
Locate on the Red Dot Pointer Mount in.
01
Jun,2019
Chiller lcd panel is showing normal, but the red light on and buzzer beeping.
Here are the.
01
Jun,2019
Here are the reasons:
● Air compressor break down
How to check if air compressor break down, there’s a.
01
Jun,2019
Here are the reasons:
● Exhaust fan break down
How to check if exhaust fan break down, there’s a.
01
Jun,2019
Here are the reasons:
● The needed focus is lost
The bending of the material.
01
Jun,2019
Here are the reasons:
● The needed focus is lost
The bending of the material or the.
01
Jun,2019
Here are the reasons:
● The laser switch is off
Please make sure laser switch is on, then open.
17
Nov,2018
Here are the reasons:
● X-axis limit switch problem
Locate on the left side of x-axis, please check if.
17
Nov,2018
Here are the reasons:
● Rotary switch is turned on
Note: The rotary-axis and y-axis can be switched, if.
17
Nov,2018
LCD panel shows the following information:
Here are the reasons:
● Water chiller(water pump)is not turned.
17
Nov,2018
LCD panel shows the following information:
This problem only appears on engraving mode, it’s.
11
Nov,2018
LCD panel shows the following information:
Here are the reasons:
● The size of the graphic.