CO2 laser cutting engraving machine processes material by heating the material with fast speed. It may cause the material burning when cutting some inflammable material like wood, leather and plastic. we must cool it.

Drive belts is an important part of getting the X,Y,Z axis moving, Low quality belts would age fast after high speed moving, this will result a bad impact on the cutting engraving effect. Thunder.

After passing through the focus lens, the laser beam is not vertical but in a cone shape. Different laser heads have different focal distances which produce different verticality of laser beam and different size.

The high pressure and low noise air compressor offered by Thunder Laser co2 laser engraving machine includes two parts: the high pressure and low noise air compressor and the water separator. High pressure air compressor:.

4” laser head is the laser head of the laser cutting machine that installed a 4” focus lens. The standard laser head is mainly used to cutting material less than 10mm. But if you.

When you need to cut thick materials like 20mm acrylic or wood on co2 laser engraving cutting machine, you should use high power rate and very slow cutting speed. If you work on normal.

If you want to use the laser engraving machine to process different kinds of material, you need to frequently modify the parameter like speed and power, besides, you need to record these parameters on.

When the laser machine running, the motor and other electronic components will produce heat, thus we need cooling fan to lower the temperature, in order to avoid the parts be damaged due to the.

Drive belts is an important part of getting the X,Y,Z axis moving, Low quality belts would age fast after high speed moving, this will result a bad impact on the cutting engraving effect. Thunder.