If your laser cutter’s LCD panel is in Chinese,it might cost you lots of time to set to English.Now Thunder laser will show you how to change Chinese to English just in a few.

As long as your door is wider than 740mm, you can divide your thunder laser cutter into two parts and pass your door without problem. Please remove the screws at the four corners of your.

If the software shows the below information: Please try the following solutions: A.Please check if the USB cable is loose or not. B.Please check if the USB is connected to the PC interface on the machine.

If this problem occurs, generally the pulse setting of the X/Y axis motors is wrong. Please follow the below steps to solve the problem Please draw a 100x100mm square using the cut mode and send to.

The problem is generally caused by two reason: 1. Belts of X axis and Y axis is loose: ① please check if X axis is loose ② please check if belt of Y axis is loose like.

There are three possibilities A. Wrong pulse setting If your laser cutter has a wrong pulse setting, the laser head might keep moving even it reaches the edge and hits the boundary. If that is the problem,.

If the LCD panel shows the following information: Here are the reasons: A.The buffer distance is out of bound This problem only appears on the engraving mode. For example, if you want to engrave a picture of 200x200mm,.

If your laser cutter’s engraving quality is very poor, it has the following possibilities: A.Laser head is loose Please fasten the laser head as below B.The focus lens or the reflective mirrors are loose Please fasten the focus.