How to import PDF files into RDWorks

Home » troubleshooting » How to import PDF files into RDWorks

1. RDWorks cannot read PDF and open it directly.

2. Use CorelDraw to open/import PDF file. Then save the graphic as DXF file.

Like below:

some trouble of laser cutter

3. Then RDWorks can read the DXF file, Just import the DXF file into RDWorks directly.

4. The other way is open/import PDF file with CorelDraw，use the plugin button “Laser Running” to import the graphic into RDWorks.

Dec,2016

There are three cases. 1. Two sides of the working table are not of the same height. Turn off the whole.

Dec,2016

Some point of the same piece of materials cannot be cut through, why? This problem is mainly caused by following.

Nov,2016

Following reasons cause the failure of laser working (has no laser beam) 1. Cooling system problem (includes water chiller) 2. Laser.

Nov,2016

1. Please check if the rotary switch is turned on,like below: PS: Turning to "O" off means all is normal. If.

Nov,2016

This problem may cause from improper setting of the software. Please start up the laser software RDWorksV8. And then click.

Nov,2016

If the file being imported is DXF format, the problem may be caused by improper software setting. For example, the.

Nov,2016

If there are several USB interfaces with your PC, it's able for one PC (laser software) to connect with.

Nov,2016

1. Firstly run CorelDraw and set the parameter following below instructions: 2. After that, close CorelDraw. Double click to open.

Jul,2016

I'd like to cut a Rectangle at 30x30mm, however, it become 30x60.2 in simulation and in laser, Please make sure.

May,2016

If your laser cutter’s LCD panel is in Chinese,it might cost you lots of time to set to English.Now.

May,2016

As long as your door is wider than 740mm, you can divide your thunder laser cutter into two parts.

May,2016

If the software shows the below information: Please try the following solutions: A.Please check if the USB cable is loose or.

Related Posts